Start Getting Crusty

Parker

• PinoTaur
  • MCP23S08
  • I/O Expanders Verse Shift Registers?
• Wagon Tach Project
  • 3D printed the housing
  • Need to run the wire from the distributor to inside the cab
  • To knock down the distributor signal
    • In series diode to prevent negative flyback? voltage from affecting circuit
    • Resistor divider
    • Zener diode to clamp to 4.7V
    • H11L1M – Schmitt Trigger Opto

Stephen

• MacroAmp Testing
  • Used a variac to bring the amp up to voltage
  • Found some of the resistances were too high
    • It can be difficult to determine what a transformer tap will produce – I chose to guesstimate and fix it later…it works
  • Higher gain when powered from the transformer. About 100x gain
  • Tested into a Power amp – Works
  • HUGE ISSUE: MICROPHONIC TUBES
  • Next steps – Get everything in the enclosure. Wire the output transformers

R.F.O.

• Chip component gets heat out of tight spots without leaking electrons
  • TT Electronics has introduced a surface-mount component designed exclusively to get heat out of tight spots.
  • SMD thermal junctions that can be placed with a pick and place
  • Can use creative thermal paths instead of more traditional “heat planes”
• Server maker Super Micro to ditch ‘made-in-China’ parts on spy fears
  • Check out Episode 142 of the MEP with Misha and Church
  • This a security move or just money due to tariffs?
  • Was there something TO the Bloomberg article that caused this to happen behind the scenes?
• On better datasheets
  • Suggested alternate reading: How to Read a Power MOSFET Datasheet
  • Manufacturers could provide a “legend” or “guide” for their family of datasheets
  • Don’t just photocopy your old datasheet and slap your name on top. Do just a little bit of effort and make a new datasheet. Also if you do photocopy anything AT LEAST DO IT STRAIGHT.

Visit our Public Slack Channel and join the conversation in between episodes!

Hosts: Parker Dillmann, Stephen Kraig

Special thanks to whixr over at Tymkrs for the intro and outro!